Remove the two screws holding the butt-plate to the aft stock. Pull the action-bar and slide-tube out the back of the fore-end. Twist the fore-end cap counter-clockwise and remove it. They were not noted for keeping pins and extractors in place as the receivers would weaken around the pins because of the soft pot metal. With the 1/8 inch flat-head screwdriver, pull the slide-bar pin back and remove the fore-end from the action and off the end of the magazine.
Those three do for certain.Manufacturing details of the Ithaca Model 49 Or it may only be that the older Winchesters, Stevens and the Remington Model 12 were the only pump shotguns that were true "take downs". ISSC Austria SPA Israel Weapon Industries (IWI) Uzi Ithaca Model 49. They looked sort of "Model NinetySevenish",but I forget if they actually and truly are "take downs". Gun Digest Book of Rimfire Rifles Assembly/Disassembly 4th Edition (Digital Ebook). Second, there are two plungers and a spring in. I've seen a few old Marlin pumps but I've always believed the old time gun books that said they were unsafe when new and worse today. Ithaca M49 Saddlegun: Junk or Treasure Oleg Volk 08.04.15 Introduced at 20 in 1961 and sold until 1979, Ithaca M49 looks like a conventional lever action repeater with 18 inch barrel. First, drive out from left to right the pin that holds the lever and remove the lever downward. What about the Spencer, the one that started it all?Īnd wasn't there an old pump shotgun called "The Standard"? Did they take down? To my knowledge, this is the only place directions for the repeat. Someone on the internet referred to it as a zinc alloy. This video pertains to the M49R, which is the lever action repeater - not the single shot. I have seen a lot of mistakes made regarding the information about the receiver/frame of the Ithaca 49. I know for certain that none of my Model 37's or 870's are true "take downs", and I don't think any of the High Standards I've owned were true take downs either.ĭid the various old Marlin shotguns take down, too? Or at least some of them? Tthe 49 was completely made in the USA but the Ithaca Model 72 Lever repeater was made by Erma Werke with the wood put on in USA. Ithaca Model 49-S (single shot) lever action 22lrThe end of the ejector was broken off and had evidently been run long after its initial breaking. w/ 24 Octagon Barrel & Weaver G4 Scope, S/N 733359 Ithaca Model 49 22 cal.
#ITHACA MODEL 49 TAKEDOWN MANUAL#
The various Stevens 520/620 series, of which I believe the "Ranger" was a store brand. Manual For Remington Model 760 Gamemaster Remington Gamemaster Model 760. The Model 97, Model 12, and Model 42 Winchester.Ģ. I've been searching my mind over all the dozens of old pump shotguns I've owned or handled, and when it comes to shotguns that can be completely taken down,the barrel along with the magazine tube still attached to the barrel and not just removing the barrel leaving the mag tube in the gun,I can only think of these for certain:ġ.
0 kommentar(er)
